Run .app file in iOS 8 simulator

问题

I have a .app file shared from a developer which i would like to run in iOS 8 simulator. I have seen similar questions which has solutions for older versions of iOS which is no longer working for iOS 8. Can someone point out what needs to be done to run the .app file in an iOS 8 simulator without using xcode.

回答1:

Boot the simulator you want to install it to in the iOS Simulator and then do the following:

xcrun simctl install booted /path/to/Your.app
xcrun simctl launch booted com.yourcompany.yourapp

The "booted" token was not supported on older versions of simctl in Xcode 6.0. If you get an error, please use the full device UDID instead of "booted". You can determine the UDID by running xcrun simctl list

回答2:

If the application crashes after installing in the simulator using the command,

xcrun simctl install booted /path/to/Your.app

It's probably because the architecture issues, since we used the device build instead of simulator build.

The basic architecture difference between the iphone simulator and iphone device is

iPhone simulator uses the architecture i386 or x86_x64

whereas,

iPhone device uses the architecture arm64 or armv7 or armv7s

We can find each device architectures in this link. So to over come this problem we need to get the simulator build by changing the xcode build location settings.

SOLUTION :

To change the build location settings, Open your xcode and follow the below steps.

1. Go to xcode preferences.
2. Choose the locations tab.
3. In the 'Derived Data:' section click 'advanced', from the resulting screen choose 'legacy'.
4. Now build the application, after successful build go to 'Your-App-Folder/build/Debug-iphonesimulator' in finder, and copy the build available on the same folder with the extension .app

5. Copy that and run the above command answered by @jeremy.

   xcrun simctl install booted /path/to/Your.app

After running this command, note that your simulator is installed with the build you specified. There you go, run the application in simulator by clicking the corresponding app and use it.

I deliberately write this solution to help the needy, those who are clueless about the architecture issues specified above.

Happy Coding :)

回答3:

iOS Simulator also supports dragging and dropping for installing .app files

1. Open Simulator
   • you can do it through XCode under XCode > Open Developer Tool > Simulator
   • to open it "without using xcode", see these answers.
2. Find the .app file in Finder and drag it into your Simulator window
3. Wait for the app to install and launch it

回答4:

For developers looking to provide a simulator build to theirs testers, these are the steps that I followed to create and test a build -

1. Add i386 in valid architectures section of build settings.

2. Open terminal and navigate to your project folder. Then execute the command -

   xcodebuild -arch i386 -sdk iphonesimulator8.1

(This will build the application)

3. To install the application on simulator, run the command mentioned in the above answer i.e -

   xcrun simctl install booted /path/to/Your.app

Now you should be able to run the app by clicking on the installed application in the simulator.

来源：https://stackoverflow.com/questions/27310453/run-app-file-in-ios-8-simulator