What is the purpose of ByteBuffer's flip method? (And why is it called “flip”?)

问题

Why does ByteBuffer's flip() method called "flip"? What is "flipped" here? According to apidoc, two successive flips won't restore original state, and multiple flips will probably tend limit() to become zero.

Can I "unflip" somehow to reuse bytes went out of a limit?

Can I concatenate tail to be flipped with some other data?

回答1:

One fairly common use case for the ByteBuffer is to construct some data structure piece-by-piece and then write that whole structure to disk. flip is used to flip the ByteBuffer from "reading from I/O" (putting) to "writing to I/O" (getting): after a sequence of puts is used to fill the ByteBuffer, flip will set the limit of the buffer to the current position and reset the position to zero. This has the effect of making a future get or write from the buffer write all of what was put into the buffer and no more.

After finishing the put, you might want to reuse the ByteBuffer to construct another data structure. To "unflip" it, call clear. This resets the limit to the capacity (making all of the buffer usable), and the position to 0.

So, a typical usage scenario:

ByteBuffer b = new ByteBuffer(1024);
for(int i=0; i<N; i++) {
    b.clear();
    b.put(header[i]);
    b.put(data[i]);
    b.flip();
    out.write(b);
}

回答2:

Flip assigns current position value to the limit property and sets the position property to 0. Flip is useful to only drain active elements from a buffer.

For example, below program prints "hello" not empty elements of buffer. Method calls limit and position can be replaced with flip.

CharBuffer cbuff = CharBuffer.allocate(40);
cbuff.put("hello"); 
// what below two line of code is what flip does
cbuff.limit(cbuff.position());
cbuff.position(0);      
while(cbuff.hasRemaining()) {
    System.out.println(cbuff.get());
}

See http://www.zoftino.com/java-nio-tutorial for more information on buffers and channels.

回答3:

ByteBuffer is ill designed. There are lots of complaints from decent programmers.

So don't try to reason about it, just study and use the API carefully.

Now I cannot badmouth it without presenting an alternative, so here it is:

A buffer has a fixed capacity; it maintains 2 pointers: start and end. get() returns the byte at the start position and increments start. put() puts the byte at the end position and increments end. No flip()!

回答4:

flip() method makes a buffer ready for a new sequence of channel-write or relative get operations: It sets the limit to the current position and then sets the position to zero.

Buffer keeps track of the data written into it. Post writing, flip() method is called to switch from writing to reading mode.

来源：https://stackoverflow.com/questions/14792968/what-is-the-purpose-of-bytebuffers-flip-method-and-why-is-it-called-flip

标签

java

flip

bytebuffer