问题
I am trying to assemble the code below using yasm. I have put 'here' comments where yasm reports the error "error: invalid size for operand 2". Why is this error happening ?
segment .data
a db 25
b dw 0xffff
c dd 3456
d dq -14
segment .bss
res resq 1
segment .text
global _start
_start:
movsx rax, [a] ; here
movsx rbx, [b] ; here
movsxd rcx, [c] ; here
mov rdx, [d]
add rcx, rdx
add rbx, rcx
add rax, rbx
mov [res], rax
ret
回答1:
For most instructions, the width of the register operand implies the width of the memory operand, because both operands have to be the same size. e.g. mov rdx, [d] implies mov rdx, qword [d] because you used a 64-bit register.
But the same movsx / movzx mnemonics are used for the byte-source and word-source opcodes, so it's ambiguous unless the source is a register (like movzx eax, cl).
movsx / movzx with a memory source always need the width of the memory operand specified explicitly.
The movsxd mnemonic is supposed to imply a 32-bit source size. movsxd rcx, [c] assembles with NASM, but apparently not with YASM. YASM requires you to write dword, even though it doesn't accept byte, word, or qword there, and it doesn't accept movsx rcx, dword [c] either (i.e. it requires the movsxd mnemonic for 32-bit source operands).
In NASM, movsx rcx, dword [c] assembles to movsxd, but movsxd rcx, word [c] is still rejected. i.e. in NASM, plain movsx is fully flexible, but movsxd is still rigid. I'd still recommend using dword to make the width of the load explicit, for the benefit of humans.
movsx rax, byte [a]
movsx rbx, word [b]
movsxd rcx, dword [c]
Note that the "operand size" of the instruction (as determined by the operand-size prefix to make it 16-bit, or REX.W=1 to make it 64-bit) is the destination width for movsx / movzx. Different source sizes use different opcodes.
In case it's not obvious, there's no movzxd because 32-bit mov already zero-extends to 64-bit implicitly. movsxd eax, ecx is encodeable, but not recommended (use mov instead).
In AT&T syntax, different source-widths have different mnemonics, like movsb or movsw. The destination size is a suffix as usual, so you can write movsbq (%rsi), %rax to be explicit or movsb (%rsi), %rax to let the assembler infer the destination size from %rax.
Other stuff about your source code:
NASM/YASM allow you to use the segment keyword instead of section, but really you're giving ELF section names, not executable segment names. Also, you can put read-only data in section .rodata (which is linked as part of the text segment). What's the difference of section and segment in ELF file format.
You can't ret from _start. It's not a function, it's your ELF entry point. The first thing on the stack is argc, not a valid return address. Use this to exit cleanly:
xor edi,edi
mov eax, 231
syscall ; sys_exit_group(0)
See the x86 tag wiki for links to more useful guides (and debugging tips at the bottom).
来源：https://stackoverflow.com/questions/47350568/yasm-movsx-movsxd-invalid-size-for-operand-2