问题
I am new to x86 assembly and I am trying to understand the code in this document : http://www.cs.cmu.edu/~410-s07/p4/p4-boot.pdf page 3 :
movw $0x1234, %ax
movw %ax, %ds
movw $0x5678, %bx
# The following instruction is the same as "movw $0x1337, (%bx)".
movw $0x1337, %ds:(%bx) # Places 0x1337 into memory word 0x179b8.
# Segment Base: %ds << 4: 12340
# Offset: %bx: + 5678
# -------
# Linear Address: 179b8
But I am not understanding the command :
movw $0x1337, %ds:(%bx) # Places 0x1337 into memory word 0x179b8.
Why concatenating %ds with (%bx) is the same as ((%ds << 4) | %bx) ?
As I am in real mode (16 bits), the concatenation shouldn't be %ds << 8 ? instead of %ds << 4?
And why the parenthesis is just around %bx? And not around the whole structure like : movw $0x1337, (%ds:%bx) ?
回答1:
In real mode, the segment register is used to provide a 20-bit address. In this case, the data segment register ds provides the 'high' 16 bits of the address: (0x1234 << 4 = 0x12340), and the offset in the segment is given by: 0x5678, to yield: 0x179b8.
The data segment register is implicit, so it's not necessary to use: ds:(%bx). If you were using another segment register, like es, it would need to be explicit.
I hope I've understood your question. As to why it's not written as (%ds:%bx), that's really just a syntactic decision that you're stuck with.
来源：https://stackoverflow.com/questions/18736663/what-does-the-colon-mean-in-x86-assembly-gas-syntax-as-in-dsbx