问题
I am currently working on a project which aim to detect Bluetooth and decode Bluetooth packets (I use a Hack RF One to make the detection). I have made a Gnuradio Flowgraph in order to demodulate Bluetooth signal and I am trying to decode visualy the packets by searching a Bluetooth frame on a binary file.
Unfortunately, I didn't succeed to recover a clear view of the Bluetooth signal. To be precise, I am pretty sure that I detect Bluetooth on my sinks but when sending this to a Clock Recovery + Binary Slicer blocks, I am unable to recover interresting data in the binary file (especially the MAC adress of the sending device, which is part of the a Bluetooth packet). Moreover, I would like to know what type of network layer (physical, transport, baseband...) is intercepted in this type of process. In my case, I aim to intercept baseband layer packets. Additionaly, I am interrested in knowing how to use the gr-bluetooth because I can't find a lot of documentation concerning this block. I think this can be interresting for the development of my project.
Could you please, give me your view, opinion about this problem ? I am stucked at this stage without knowing the exact origin of my issue. (Here is my flowgraph GnuRadio_Flowgraph and a screenshot of one of my Bluetooth detection Detected signal at 2.402GHz).
Thank you very much,
回答1:
You probably need an ubertooth instead https://www.sparkfun.com/products/10573 I read that the bluetooth frequency skipping is spread wider than the HackRF can read, so at-best, you're going to miss 75% of frames if you only have one hackrf connected.
来源：https://stackoverflow.com/questions/50208704/decoding-bluetooth-signal-and-packets-using-gnuradio