问题
The x86 CPU begins execution at physical address 0xFFFFFFF0. There at the end of the address space the BIOS ROM is located. The first instruction the CPU executes from the ROM is far jump which causes the CS segment to be reloaded so the next instruction is executed from within the physical region 0x000F0000 - 0x000FFFFF.
What causes the ROM to respond on both regions? Is there some special address decoding logic on PC? I found comment in Bochs source code that states that last 128K of BIOS ROM is mapped to 0xE0000 - 0xFFFFF. However I cannot find more info about this. Clearly this is something PC specific since I have x86 embedded board and such mirroring does not happen there. I can only use near jump.
回答1:
On the PC there's always some address decoding logic involved because there are a few "holes/windows" in the physical address space through which the BIOS ROM and I/O devices (e.g. video card) are accessible instead of the RAM. That's by design, for compatibility reasons, so older programs can still run on newer computers.
As for the initial address at which the CPU starts execution after a reset, if you look at the documentation, you will see that Pentium-class CPUs start with this:
EIP=0xFFF0
CS.Selector=0xF000
CS.Base=0xFFFF0000
If you follow the normal real-mode addressing scheme, the physical address should be CS.Selector*16+IP, or, with the values substituted, 0xFFFF0. However, the CPU actually calculates the address using CS.Base+(E)IP (in the real and 16/32-bit protected mode, but not in virtual 8086 or 64-bit protected mode), hence the first address that the CPU requests from the memory is going to be 0xFFFFFFF0. Your inability to use far jumps to code within the ROM at that high address may be due to the fact that loading into CS will reset CS.Base to 16 * the new value of CS.Selector. So, jumping to, say, 0xF000:0xFFF0 will transfer control to 0xFFFF0 instead of 0xFFFFFFF0 and unless the ROM is also mapped at that low location in the memory and the code in it is suited for running with CS(.Selector)=0xF000, it's not going to run.
Also, neither the CPU nor the circuitry around it has to support all 32 (or more) address lines if the PC is limited to have at most 16MB (as it was on i80286 and i80386SX) or 4GB (as it was on i80386DX/original i80386 and i80486) or 240-52 bytes (on 64-bit capable Pentium-class CPUs) and if that's the case, if a number of high bits in the physical address space are ignored, execution can be said to effectively start at an address lower than the theoretical maximum - 16, e.g. 0x00FFFFF0 (i80286/i80386SX).
If you need to resolve problems with your board, see its documentation and schematics to find out how the ROM is mapped into the physical address space on it.
来源：https://stackoverflow.com/questions/7804724/how-is-the-bios-rom-mapped-into-address-space-on-pc