INFO No non-zero metrics in the last 30s message in filebeat

问题

I'm new to ELK and I'm getting issues while running logstash. I ran the logatash as defined in below link https://www.elastic.co/guide/en/logstash/current/advanced-pipeline.html

But when run filebeat and logstash, Its show logstash successfully runs at port 9600. In filebeat it gives like this

INFO No non-zero metrics in the last 30s

Logstash is not getting input from filebeat.Please help..

the filebeat .yml is

 filebeat.prospectors:
 - input_type: log
 paths:
 - /path/to/file/logstash-tutorial.log 
 output.logstash:
 hosts: ["localhost:5043"]

and I ran this command sudo ./filebeat -e -c filebeat.yml -d "publish"

The config file is

input {
    beats {
         port => "5043"
     }
  }

output {
     stdout { codec => rubydebug }
}

then ran the commands

 1)bin/logstash -f first-pipeline.conf --config.test_and_exit - this        gave warnings
2)bin/logstash -f first-pipeline.conf --config.reload.automatic -This started the logstash on port 9600

I couldn't proceeds after this since filebeat gives the INFO

INFO No non-zero metrics in the last 30s

And the ELK version used is 5.1.2

回答1:

The registry file stores the state and location information that Filebeat uses to track where it was last reading

So you can try updating or deleting registry file. see here

cd /var/lib/filebeat
sudo mv registry registry.bak
sudo service filebeat restart

I have also faced this issue and I have solved with above commands.

回答2:

Filebeat reads from the end of your file, and is expecting new stuff to be added over time (like a log file).

To make it read from the beginning of the file, set the 'tail_files' option.

Also note the instructions there about re-processing a file, as that can come into play during testing.

来源：https://stackoverflow.com/questions/41949989/info-no-non-zero-metrics-in-the-last-30s-message-in-filebeat

标签

logstash

filebeat