问题
I am working on Holepunching using UDP and UDT. For the final testing I need to test the application on different NAT types (Symmetric,full cone,restricted cone, port restricted NATs).
Is there any method I can simulate these? What I expect here is some kind of virtual-Box setup. Can I use PC as a router so that I can configure according to my needs?
In general how do we test applications for different network conditions?
回答1:
I think you already answered your own question, use VirtualBox (or VMware, Xen, etc..).
I've done this very thing successfully by setting up mini-lans of VM's. If you're looking for software to act as your router inside a VM, I'd start off at http://www.pfsense.org/ and see if that meets your needs. It's a FreeBSD distribution tailored for being an easy to install router/firewall with a nice web management UI and all of that.
If pfsense doesn't fit your needs, there are plenty of other linux/bsd distributions out there that are tailored for this kind of stuff and that you can install in a VM: http://en.wikipedia.org/wiki/List_of_router_or_firewall_distributions for a good list :) (I've heard good things about OpenWRT and ClearOS as well.)
回答2:
Just in case someone else is looking to do this, this website explains how to set up the different NAT environments using IPTables.
Update
It has been a few years since I did this, given that the link was placed behind a login, and the rewind was also placed behind a login, I went through my notes from back than and found the following. Please note these are untested.
Full Cone NAT;
iptables -t nat -A POSTROUTING -o eth1 -j SNAT --to-source "public IP"
iptables -t nat -A PREROUTING -i eth1 -j DNAT --to-destination "private IP"
Restricted Cone NAT;
iptables -t nat POSTROUTING -o eth1 -p udp -j SNAT --to-source "public IP"
iptables -t nat PREROUTING -i eth1 -p udp -j DNAT --to-destination "private IP"
iptables -A INPUT -i eth1 -p udp -m state --state ESTABLISHED,RELATED -j ACCEPT
iptables -A INPUT -i eth1 -p udp -m state --state NEW -j DROP
Port Restricted Cone NAT;
iptables -t nat -A POSTROUTING -o eth0 -j SNAT --to-source "public IP"
Symmetric NAT;
echo "1" >/proc/sys/net/ipv4/ip_forward
iptables --flush
iptables -t nat -A POSTROUTING -o eth1 -j MASQUERADE --random
iptables -A FORWARD -i eth1 -o eth0 -m state --state RELATED,ESTABLISHED -j ACCEPT
iptables -A FORWARD -i eth0 -o eth1 -j ACCEPT
来源：https://stackoverflow.com/questions/11719572/how-to-simulate-different-nat-behaviours