问题
I feel I don't really understand the concept of overflow and underflow. I'm asking this question to clarify this. I need to understand it at its most basic level with bits. Let's work with the simplified floating point representation of 1 byte - 1 bit sign, 3 bits exponent and 4 bits mantissa:
0 000 0000
The max exponent we can store is 111_2=7 minus the bias K=2^2-1=3 which gives 4, and it's reserved for Infinity and NaN. The exponent for max number is 3, which is 110 under offset binary.
So the bit pattern for max number is:
0 110 1111 // positive
1 110 1111 // negative
When the exponent is zero, the number is subnormal and has implicit 0 instead of 1. So the bit pattern for min number is:
0 000 0001 // positive
1 000 0001 // negative
I've found these descriptions for single-precision floating point:
Negative numbers less than −(2−2−23) × 2127 (negative overflow)
Negative numbers greater than −2−149 (negative underflow)
Positive numbers less than 2−149 (positive underflow)
Positive numbers greater than (2−2−23) × 2127 (positive overflow)
Out of them I understand only positive overflow which results in +Infinity, and the example would be like this:
0 110 1111 + 0 110 1111 = 0 111 0000
Can anyone please demonstrate the three other cases for overflow and underflow using the bit patterns I outlined above?
回答1:
Of course the following is implementation dependent, but if the numbers behave anything like what IEEE-754 specifies, Floating point numbers do not overflow and underflow to a wildly incorrect answer like integers do, e.g. you really should not end up with two positive numbers being multiplied resulting in a negative number.
Instead, overflow would mean that the result is 'too large to represent'. Depending on the rounding mode, this either usually gets represented by max float(RTZ) or Inf (RNE):
0 110 1111 * 0 110 1111 = 0 111 0000
(Note that the overflowing of integers as you know it could have been avoided in hardware by applying a similar clamping operation, it's just not the convention to do that.)
When dealing with floating point numbers the term underflow means that the number is 'too small to represent', which usually just results in 0.0:
0 000 0001 * 0 000 0001 = 0 000 0000
Note that I have also heard the term underflow being used for overflow to a very large negative number, but this is not the best term for it. This is an example of when the result is negative and too large to represent, i.e. 'negative overflow':
0 110 1111 * 1 110 1111 = 1 111 0000
来源：https://stackoverflow.com/questions/40082459/what-is-overflow-and-underflow-in-floating-point