Dockerfile: Setting multiple environment variables in single line

Question

I was under the impression that environmental variables could be set on a single line as follows so as to minimize intermediary images.

FROM alpine:3.6
ENV RUBY_         


        

Answer 1

There are two formats for specifying environments. If you need single variable then you below format

ENV X Y

This will assign X as Y

ENX X Y Z

This will assign X as Y Z

If you need to assign multiple environment variables then you use the other format

ENV X=Y Z=A

This will assign X as Y and Z as A. So your Dockerfile should be

FROM alpine:3.6
ENV RUBY_MAJOR=2.4 \
    RUBY_VERSION=2.4.1 \
    RUBY_DOWNLOAD_SHA256=4fc8a9992de3e90191de369270ea4b6c1b171b7941743614cc50822ddc1fe654 \
    RUBYGEMS_VERSION=2.6.12 \
    BUNDLER_VERSION=1.15.3

RUN env

Answer 2

You do not need to worry about many ENV commands each creating a new intermediate layer for your final image created by your Dockerfile.

from Best practices for writing Dockerfiles

Minimize the number of layers

Prior to Docker 17.05, and even more, prior to Docker 1.10, it was important to minimize the number of layers in your image. The following improvements have mitigated this need:

• In Docker 1.10 and higher, only RUN, COPY, and ADD instructions create layers. Other instructions create temporary intermediate images, and no longer directly increase the size of the build.

• Docker 17.05 and higher add support for multi-stage builds, which allow you to copy only the artifacts you need into the final image. This allows you to include tools and debug information in your intermediate build stages without increasing the size of the final image.