Ghostscript PDF -> TIFF conversion is awful for me, people rave about it, I alone look sullen [closed]

Answer 1

setori's command does not specify the resolution to use for the tiffg4 output. The consequence is: Ghostscript will use its default setting for that output, which is 204x196dpi.

In order to increase the resolution to 600dpi, add a -r600 commandline parameter:

gswin32c.exe ^
   -o output.tiff ^
   -sDEVICE=tiffg4 ^
   -r600 ^
    input.pdf

Also note that TIFFG4 is the standard fax format and as such it uses black+white/grayscale only, but no colors.

@jeff: Have you ever tried the -dDITHERPPI=<lpi> parameter with Ghostscript? (Reasonable values for lpi are N/5 to N/20, where N is the resolution in dpi. So for -r600 use try with -dDITHERPPI=30 to dDITHERPPI=120).

Answer 2

It is quite nice for a fax! ;-)

danio's answer is probably the best, if you need a color copy.

I notice also, from the linked thread, that you omitted to specify DPI for the output, hence the bad look... If you need pure dithered B&W, you should use a higher resolution.

I also got a good looking image using NConvert

nconvert -page 1 -out tiff -dpi 200 -c 2 -o c.tif FMD.pdf

I mention it for the record, because I think you need a license to redistribute it (it is free for personal use otherwise).

Answer 3

tiffg4 is a black&white output device. You should use tiff24nc or tiff12nc as the output device colour PDFs - see ghostscript output devices. These will be uncompressed but you could put the resulting TIFFs through imagemagick or similar to resave as compressed TIFF.

Answer 4

Like other posts suggested, use a color format (e.g. -sDEVICE=tiff24nc) and specify a higher resolution (e.g. -r600x600):

gswin32c.exe -q -dNOPAUSE -r600 -sDEVICE=tiff24nc -sOutputFile=a.tif a.pdf -c quit

Answer 5

I have been using ImageMagick for quite a sometime. It's very nice tool with a lot of features.

Install ImageMagick and run following command. This is what I used on Linux, you may have to replace convert with the correct one.

Below command converts PDFs to CCITT Group 3 standard TIFs (Fax standard):

convert -define quantum:polarity=min-is-white \
        -endian MSB \
        -units PixelsPerInch \
        -density 204x196 \
        -monochrome \
        -compress Fax \
        -sample 1728 \
        "input.pdf" "output.tif"

Also you may use GraphicsMagick, it is also similar to ImageMagick, but ImageMagick more concerns with quality than speed.

Answer 6

Thanks guys this is what I ended up with

     os.popen(' '.join([
                       self._ghostscriptPath + 'gswin32c.exe', 
                       '-q',
                       '-dNOPAUSE',
                       '-dBATCH',
                       '-r800',
                       '-sDEVICE=tiffg4',
                       '-sPAPERSIZE=a4',
                       '-sOutputFile=%s %s' % (tifDest, pdfSource),
                       ]))