zigbee motion detect sensor usage

Question

My prior experience is able to receive the data sent from my temperature / humidity zigbee sensor. Also, I am able to send the command to control the zigbee power meter/swi

Answer 1

Why do you say it is not joining the network, have you verified with a packet sniffer that it is not joining and sending a device announce, or is it not sending reports or responding to read attributes in the same way as your temp/humidity sensors?

If it is really not joining then there maybe a button on the IAS device that will trigger a join. Or it may already be connected to a network and need resetting.

After you have joined the IAS Zone device to the network the IAS device will not automatically send reports like the temp/humidity sensors. You will need to enroll it first. Do this by writing the CIE IEEE Address attribute for the IAS Zone Endpoint and set it to the IEEE address of you Gateway (or CIE). You may need to discover the endpoint ID with active EP request, and Simple Descriptor Request. After setting the CIE IEEE Address attribute it should then send a Zone Enrollment Request, you should send a Zone Enrollment Response and then the IAS Zone device will send Gateway/CIE Zone State Change Notifications when an Alarm or other Zone event is triggered.

For more info on the CIE IEEE Address attribute and the Zone Enrollment Req/Rsp refer to the ZCL Specification http://www.zigbee.org/download/standards-zigbee-cluster-library/.

Regards, TC.