GFSK modulation/demodulation with GNU Radio and USRP

Question

Im currently creating a satellite ground station which will be used to control our cubesat in coming months. The modulation scheme used is GFSK and the baud rate is 9600. I

Answer 1

I was finally able to solve the problem. All I did was re-implementing the GFSK demod in GRC. If you go into source of gfsk.py, you will find out that the blocks used are Quadrature Demod --> M&M Clock recovery --> Binary slicer which can easily be connected in GRC directly. As Marcus suggested in my other thread, GFSK demodulation with Xlating filter in GNU Radio , I replaced the M&M Clock recovery block with PFB block. My flowgraph is shown below.

Answer 2

Even if I can not answer all of your questions, I provide below some thoughts:

1. When using hardware devices the Throttle MUST be removed from the flow-graph. The hardware device is now responsible for the rate limiting. Mixing hardware device and the Throttle block may break the real-time boundary of your flow-graph required by the device. Underflows or Overflows messages should be produced by the UHD driver in such a case.

2. Are you sure that the USRP can support the requested sampling rate? You may need also to change the master_clock_rate of the device, if the requested sampling rate is not an integer decimation of the clock. If this is not possible consider some kind of re-sampling.

EDIT: The B200 can not provide 192e3 sampling rate with the default clock. You can set the master_clock_rate at 19.2e6. The hardware will apply then the proper decimation. The master_clock_rate can be changed either by the device specific arguments or the Clock Rate field of the UHD Sink/Source blocks that presents in the latests GNU Radio versions.