check if VT-x is activated without having to reboot in Linux?

Question

I have a laptop with Intel Core i5 M 450 @ 2.40GHz which apparently has VT-x but not VT-d. I have Ubuntu 12.04 32bit but would like to have a virtual 64bit terminal-based Li

Answer 1

You can use

sudo kvm-ok

from cpu-checker. On Intel, which has the most complicated logic, kvm-ok checks that if bit 0 of rdmsr 0x3a (the lock bit) is set, bit 2 (which allows virt use outside of SMX mode, something to do with trusted boot) must also be set. If the output of rdmsr 0x3a is anything but 1 or 3, you will be able to use kvm. kvm will set bit 2 of the msr if necessary, I expect virtualbox and the rest have the same logic.

Answer 2

A simple approach to confirm that Vt-D is enabled in the BIOS is through the Linux system. If the VT-D is enable in the BIOS and Iommu=on in the grub.cfg then the below folder structure is created automatically to hold the Virtual devices.

/sys/kernel/iommu_groups/0/devices/0000:00:00.0

Whereas if either one of the options VT-D or Iommu is not configured/enabled then the above mentioned folder structure is not created. This behavior is confirmed in CentOS 7.4 and Ubuntu. Hopefully this behavior is similar for other operating systems as well but this would need to be confirmed.

Answer 3

you can use:

sudo apt-get update
sudo apt-get install cpu-checker
kvm-ok

Answer 4

I found that scai's answer doesn't work on my AMD Ryzen systems.

This however works really well for me, even on Intel:

if systool -m kvm_amd -v &> /dev/null || systool -m kvm_intel -v &> /dev/null ; then
    echo "AMD-V / VT-X is enabled in the BIOS/UEFI."
else
    echo "AMD-V / VT-X is not enabled in the BIOS/UEFI"
fi

(systool is found in the sysfsutils package on most distros.)

For Intel's VT-D / AMD's IOMMU, I came up with this solution:

if compgen -G "/sys/kernel/iommu_groups/*/devices/*" > /dev/null; then
    echo "AMD's IOMMU / Intel's VT-D is enabled in the BIOS/UEFI."
else
    echo "AMD's IOMMU / Intel's VT-D is not enabled in the BIOS/UEFI"
fi

(It even worked for me if the iommu kernel parameters are not set.)

Answer 5

Install cpu-checker and run "kvm-ok"

If the CPU is enabled, you should see something like:

INFO: /dev/kvm exists
KVM acceleration can be used

othewise

INFO: /dev/kvm does not exist
HINT:   sudo modprobe kvm_intel
INFO: Your CPU supports KVM extensions
INFO: KVM (vmx) is disabled by your BIOS
HINT: Enter your BIOS setup and enable Virtualization Technology (VT),
   and then hard poweroff/poweron your system
KVM acceleration can NOT be used

Answer 6

You can use rdmsr from msr-tools to read register IA32_FEATURE_CONTROL (address 0x3a). The kernel module msr has to be loaded for this.

On most Linux systems:

sudo modprobe msr
sudo rdmsr 0x3a

Values 3 and 5 mean it's activated.