Paramiko capturing command output

Question

I have an issue that has been giving me a headache for a few days. I am using the Paramiko module with Python 2.7.10 and I\'d like to issue multiple commands to a Brocade ro

Answer 1

For your second question: Though I am not specialist of paramiko, I see that function recv, according to the doc, returns a string. If you apply a for loop on a string, you will get characters (and not lines as one might perhaps expect). The newline is caused by your use of the print function as explained on this page, at paragraph 6.3.

I haven't studied what paramiko suggests to do. But why don't you treat the full string as a single entity? For example, you could check the presence of "up" as:

if "up" in output:

Or, if that suits your needs better, you could split the string into lines and then do whatever test you want to do:

for line in output.split('\n'): 

Answer 2

If you can, the exec_command() call provides a simpler mechanism to invoke a command. I have seen Cisco switches abruptly drop connections that try exec_command(), so that may not be usable with Brocade devices.

If you must go the invoke_shell() route, be sure to clear all pending output after connecting and after send('terminal length 0\n'), checking recv_ready() before calling recv() to avoid blocking on reading data that might not ever arrive. Since you are controlling an interactive shell, sleep() calls might be needed to allow the server adequate time to process and send data, or it might be necessary to poll the output string to confirm that your last command completed by recognizing the shell prompt string.

Answer 3

After reading all of the comment I have made the following changes:

#!/usr/bin/env python
import paramiko, time

router = 'r2.test.example.com'
password = 'password'
username = 'testuser'

ssh = paramiko.SSHClient()
ssh.set_missing_host_key_policy(paramiko.AutoAddPolicy())
ssh.connect(router, username=username, password=password)
print('Successfully connected to %s' % router)

remote_conn = ssh.invoke_shell()
output = remote_conn.recv(1000)

# Disable paging on Brocade.
remote_conn.send('terminal length 0\n')
time.sleep(2)
# Clearing output.
if remote_conn.recv_ready():
    output = remote_conn.recv(1000)

# Check interface status.
remote_conn.send('show interfaces ethernet 4/1\n') # I only want output from this command.
time.sleep(2)
# Getting output I want.
if remote_conn.recv_ready():
    output = remote_conn.recv(5000)
print(output)

# Test: Check if interface is up.
for line in output.split('\n'):
    if 'line protocol is up' in line:
        print(line)

Everything works great now.

Thank you for all the help.

Best regards,

Aaron C.