How to get an accurate 1ms Timer Tick under WinXP

Question

I try to call a function every 1 ms. The problem is, I like to do this with windows. So I tried the multimediatimer API.

Multimediatimer API

Source

<

Answer 1

Without going to a real-time OS, you cannot expect to have your function called every 1 ms.

On Windows that is NOT a real-time OS (for Linux it is similar), a program that repeatedly read a current time with microsecond precision, and store consecutive differences in an histogram have a non-empty bin for >10 ms! This means that sometimes you will have 2 ms, but you can also get more between your calls.

Answer 2

You can try to run timeBeginPeriod(1) at the program start and timeEndPeriod(1) before quitting. This probably can enhance timer precision.

Answer 3

A call to NtQueryTimerResolution() will return a value for ActualResolution. In your case the actual resolution is almost certainly 0.9765625 ms. This is exactly what you show in the first plot. The second occurace of about 1.95 ms is more precisely Sleep(1) = 1.9531 ms = 2 x 0.9765625 ms

I guess the interrupt period runs at someting close to 1ms (0.9765625).

And now the trouble begins: The timer signals when the desired delay expires.

Say the ActualResolution is set to 0.9765625, the interrupt heartbeat of the system will run at 0.9765625 ms periods or 1024 Hz and a call to Sleep is made with a desired delay of 1 ms. Two scenarios are to be looked at:

1. The call was made < 1ms (ΔT) ahead of the next interrupt. The next interrupt will not confirm that the desired period of time has expired. Only the following interrupt will cause the call to return. The resulting sleep delay will be ΔT + 0.9765625 ms.
2. The call was made >= 1ms (ΔT) ahead of the next interrupt. The next interrupt will force the call to return. The resulting sleep delay will be ΔT.

So the result depends a lot on when the call was made and therefore you may observe 0.98ms events as well as 1.95ms events.

Edit: Using the CreateTimerQueueTimer will push the observed delay to 1.95 because the timer tick (interrupt period) is 0.9765625 ms. On the first occurence of the interrupt, the requested duration of 1 ms has not quite expired, thus the TimerProc will only be triggered after the second interrupt (2 x 0.9765625 ms = 1.953125 ms > 1 ms). Consequently, the queueTimer plot shows the peak at 1.953125 ms.

Note: This behavior strongly depends on the underlying hardware.

More details can be found at the Windows Timestamp Project