Trouble including httparty in ruby on rails

前端 未结 6 1566
迷失自我
迷失自我 2021-02-18 23:16

I\'ve been trying to use HTTParty in my rails code

sudo gem install httparty

From the command line I can now successfully do

ht         


        
相关标签:
6条回答
  • 2021-02-18 23:54

    1)include the httpary in your gemfile

    open your gem file then add

     gem 'httparty','YOUR VERSION NUMBER'
    

    2) run bundle install in your command prompt of the app file

    3) restart the server

    0 讨论(0)
  • 2021-02-18 23:59

    Ran into the same problem. Then I switched from Ruby 1.8.7 to Ruby 1.9.2 and all errors varnished into thin air.

    (Yes, it first took me quite some hours to come up with the possibility that the Ruby version might be the problem. Configured a secundairy server to avoid possible conflicts with 2 ruby versions, and after way to many hours I got my RoR stack up and running. And the first test with httparty (based on the example on top) worked out of the box! Finally can sleep RESTfully again :-)

    0 讨论(0)
  • 2021-02-18 23:59

    I run into the same error whilst reviewing a project from a student, I change the name of the Gem from uppercase to lowercase then run bundle install. I then went ahead to change the format in which they were being imported from require 'HTTParty' to require 'httparty' and boom it worked

    0 讨论(0)
  • 2021-02-19 00:07

    The problem is, if you load a new gem, you have to restart the server even if you are in development.

    0 讨论(0)
  • 2021-02-19 00:14

    You don't need to do 'include HTTParty' inside the Controller. Just remove that and it should work. I just tested it and it worked for me. If this doesn't work for you, you should add the gem to your environment.

    Usually if you use a gem inside your Rails application, you should add the following to environment.rb:

    config.gem "httparty"
    

    The gem will be available in the application now and you don't need to add 'require' inside the Controller. Also, you don't need to require RubyGems inside a Controller.

    When you use Rails 3, you need to put the following inside the Gemfile:

    gem "httparty"
    

    I hope it works for you. :)

    0 讨论(0)
  • 2021-02-19 00:17

    I had this same error. I tried moving the require HTTParty all over, but found, all I needed to do was restart the rails server In the end I did not need to 'require HTTParty' nor 'include' it. It just needed to be loaded into rails.

    0 讨论(0)
提交回复
热议问题