Why is the initialCapacity of Hashtable 11 while the DEFAULT_INITIAL_CAPACITY in HashMap is 16 and requires a power of 2?

Question

Comparing the HashMap and Hashtable source code in JDK 1.6, I saw the below code inside HashMap:

/**
 * The default initial capacity -          


        

Answer 1

The following article addresses this question in some detail: HashMap requires a better hashCode() - JDK 1.4 Part II.

According to that article, the main reason to move to power-of-two sizes was that bit masking is faster than integer division. This is not without adverse consequences, which are explained by one of the original authors:

Joshua Bloch: The downside of using a power-of-two is that the resulting hash table is very sensitive to the quality of the hash function (hashCode). It is imperative that any change in the input must affect the low order bits of the hash value. (Ideally, it should affect all bits of the hash value with equal likelihood.) Because we have no assurance that this is true, we put in a secondary (or "defensive") hash function when we switched to the power-of-two hash table. This hash function is applied to the results of hashCode before masking off the low order bits. Its job is to scatter the information over all the bits, and in particular, into the low order bits. Of course it has to run very fast, or you lose the benefit of switching to the power-of-two-sized table. The original secondary hash function in 1.4 turned out to be insufficient. We knew that this was a theoretical possibility, but we thought that it didn't affect any practical data sets. We were wrong. The replacement secondary hash function (which I developed with the aid of a computer) has strong statistical properties that pretty much guarantee good bucket distribution.