Tell when Bluetooth module connects on Arduino

Question

I\'m working on a project with Android and Arduino and am trying to figure out how on the Arduino side to tell if the Bluetooth is connected or not.

I\'m using one of

Answer 1

AT+STATE? will return the current state of the connection. Yes you will need to enter at mode, that is done by bringing up pin 11 HIGH on the HC05 module. It does require soldering but it's kinda worth it. It then allows full AT control of the device, then set it LOW to return it to normal working mode.

Another option, which I don't fully understand, is the AT+MPIO? command, which returns the state of all the pins in some strange masked format I don't understand yet.

I use the first option above so that I can terminal (Bluetooth) from my phone to the HC05 and switch on a led/relay etc (ie bring up pin 2 to HIGH) on the HC05. This required entering AT mode (pin 11 HIGH), sending the command AT+PIO=2,1 and then setting pin 11 to LOW to return to normal working mode.

Note: I noticed I had to put a 200ms delay in between high and AT and LOW commands. Angela's solution is nice - I use a cheap XBEE Bluetooth module (HC-05 Bluetooth Bee Master & Slave Module with Bluetooth XBee for Arduino uk2015) 2 units(HC05/6) for 5Stg which are laid out in XBEE format - handy for the 3.3v.