How do I setup REPL on vim?

Question

I have installed vimclojure to make it easier to start learning clojure. But, I haven\'t been able to setup REPL inside vim. This is essentially because I was not able to write

Answer 1

Most likely there is an error occurring in the plugin before the VimClojure mappings are fully defined.

One likely scenario that I have run into several times occurs when the Clojure source file has syntax errors when it's loaded into the Vim buffer.

There's something going on in the plugin during the load of the source file (syntax highlighting or something) that errors out and prevents the mappings from getting defined.

This is probably just an unfortunate issue with VimClojure and should be reported, but I haven't had time to dig enough and log an intelligent bug report/patch.

To troubleshoot, with a Clojure source file open in current buffer, try doing this:

:call vimclojure#Repl.New()

This invokes the function inside the plugin that is mapped to \sr. It's not a recommended way of launching the Repl, but since we're just troubleshooting your configuration, hopefully it will reveal something meaningful to you.

Also, do this to see if there happen to be any helpful messages getting logged.

:messages