GDB Monitor commands in CLion

Question

I\'m trying to debug an embedded project using remote GDB. My system:

• Target: ARM Cortex M0.
• SEGGER J-Link GDB Server V6.10 Command Line Version

Answer 1

CLion doesn't block any particular command from .gdbinit on purpose. The thing is, these commands are executed on the debugger startup, before attaching to the target. That means that the monitor reset command gets executed without a remote session being run yet, hence it fails.

Just to clarify:

• here's what happens when you execute GDB manually:

  # commands from .gdbinit
  target remote localhost:2331
  set verbose on
  file "/path_to_output_file/blinky.elf"
  monitor reset
  break main
  

• here's what happens when you execute GDB from CLion with the same .gdbinit file:

  # commands from .gdbinit
  target remote localhost:2331
  set verbose on
  file "/path_to_output_file/blinky.elf"
  monitor reset
  break main
  
  # commands executed by CLion to attach
  target remote localhost:2331  # <- ERROR (A program is being debugged already)
  

• and here's what's going on when you execute GDB from CLion with the attach command removed:

  # commands from .gdbinit
  set verbose on
  file "/path_to_output_file/blinky.elf"
  monitor reset  # <- ERROR not attached to remote gdbserver => unknown command
  
  # ... not executed due to the error above
  break main
  # commands executed by CLion to attach
  target remote localhost:2331
  

The issues you linked are totally the right ones, please feel free to vote (disclaimer: I'm one of CLion developers). I couldn't come up with a reasonable workaround to suggest you for now, I'm afraid.

Update:

There actually is a workaround for your use case that works for both CLion and terminal debug sessions. You can use GDB hooks to achieve that.

In your .gdbinit file replace the commands in question with the following lines:

define target hookpost-remote
file "/path_to_output_file/blinky.elf"
monitor reset
break main
end

This way, every time the remote target is connected, the GDB will execute the commands specified in the defined hook, regardless the way you start the debugger, either from CLion or from a terminal.